Testing The Cable On An Ethernet Port; Maintaining And Displaying An Ethernet Port - H3C S3610-28P Operation Manual

Operation Manual – Port Correlation Configuration
H3C S3610&S5510 Series Ethernet Switches
Note:
The mdi command is not supported on a Combo optical port.

1.1.11 Testing the Cable on an Ethernet Port

Note:
The optical ports of a Combo ports do not support this feature. The support of other
Ethernet ports for this feature depends on the device model.
A link in the up state goes down and then up automatically if you perform the
operation described in this section on one of the Ethernet ports forming the link.
Follow these steps to test the current operating state of the cable connected to an
Ethernet port:
Enter system view
Enter Ethernet port view
Test the current operating state of
the cable connected to the port

1.2 Maintaining and Displaying an Ethernet port

Display the current state
of a specified port and
related information
Display a summary of a
specified port
Reset the statistics of a
specified port
Display the Combo ports
and the corresponding
optical/electrical ports
To do...
To do...
display interface [ interface-type
[ interface-number ] ]
display brief interface
[ interface-type
[ interface-number ] ] [ | { begin |
include | exclude} text ]
reset counters interface
[ interface-type
[ interface-number ] ]
display port combo
Chapter 1 Ethernet Port Configuration
Use the command...
system-view
interface interface-type
interface-number
virtual-cable-test
Use the command...
1-9
Remarks
—
—
Required
Remarks
Available in any
view
Available in any
view
Available in user
view
Available in any
view