H3C S3610-28P Operation Manual page 316

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
3.5.2 Configuration Procedure
Follow these steps to configure a 6to4 tunnel:
Enter system view
Enable IPv6
Create a tunnel interface and
enter tunnel interface view
Configure an
IPv6 address
for the tunnel
interface
Set a 6to4 tunnel
Configure a source address or
interface for the tunnel
To do...
Configure an
IPv6 global
unicast
address or
site-local
address
Configure an
IPv6 link-local
address
Chapter 3 Tunneling Configuration
Use the command...
system-view
ipv6
interface tunnel number
ipv6 address
{ ipv6-address
prefix-length |
ipv6-address/prefix-length
}
ipv6 address
ipv6-address/prefix-length
eui-64
ipv6 address auto
link-local
ipv6 address
ipv6-address link-local
tunnel-protocol
ipv6-ipv4 6to4
source { ip-address |
interface-type
interface-number }
3-16
Remarks
—
Required
By default, the IPv6
packet forwarding
function is disabled.
Required
By default, there is
no tunnel interface
on the device.
Required.
Use either
command.
By default, no IPv6
global unicast
address or site-local
address is
configured for the
tunnel interface.
Optional
By default, a
link-local address
will automatically be
generated when an
IPv6 global unicast
address or site-local
address is
configured.
Required
By default, the
tunnel mode is
manual. The same
tunnel type should
be configured at
both ends of the
tunnel. Otherwise,
packet delivery will
fail.
Required
By default, no
source address or
interface is
configured for the
tunnel.