Displaying And Maintaining Voice Vlan; Voice Vlan Configuration Examples - H3C S3610-28P Operation Manual

Operation Manual – VLAN
H3C S3610&S5510 Series Ethernet Switches
Note:
Only one VLAN of a device can have the voice VLAN function enabled at a time, and
the VLAN must be an exsiting static VLAN.
A port that has the Link Aggregation Control Protocol (LACP) enabled cannot have
the voice VLAN feature enabled.
If a port is enabled with voice VLAN and works in the manual voice VLAN mode, you
need to add the port to the voice VLAN manually to make the voice VLAN takes
effect on the port.

2.3 Displaying and Maintaining Voice VLAN

Display the voice VLAN state
Display the OUI addresses
currently supported by system

2.4 Voice VLAN Configuration Examples

2.4.1 Automatic Voice VLAN Mode Configuration Example
I. Network requirement
Create VLAN 2 and configure it as a voice VLAN with an aging time of 100
minutes.
The voice traffic sent by the IP phones is tagged. Configure Ethernet 1/0/1 as a
Hybrid port and as the access port, with VLAN 6 as the default VLAN.
The device allows voice packets from Ethernet 1/0/1 with an OUI address of
0011-2200-0000 and a mask of ffff-ff00-0000 to be forwarded through the voice
VLAN.
To do...
2-7
Chapter 2 Voice VLAN Configuration
Use the command...
display voice vlan state
display voice vlan oui
Remarks
Available in any
view
Available in any
view