H3C S3610-28P Operation Manual page 225

Operation Manual – MSTP
H3C S3610&S5510 Series Ethernet Switches
Configuring
Leaf Nodes
Performing mCheck
Configuring the VLAN Ignore Feature
Configuring Digest Snooping
Configuring No Agreement Check
Configuring Protection Functions
Configuring the Function of Transmitting BPDUs Transparently
Configuring the Function of Tagging BPDUs
Note:
If both GVRP and MSTP are enabled on a device at the same time, GVRP packets will
be forwarded along the CIST. Therefore, if both GVRP and MSTP are running on the
same device and you wish to advertise a certain VLAN within the network through
GVRP, make sure that this VLAN is mapped to the CIST (instance 0) when configuring
the VLAN-to-instance mapping table. For detailed information of GVRP, refer to GVRP
Configuration of the Access Volume.
Task
Configuring an MST Region
Configuring the Work Mode of MSTP Device
Configuring the Timeout Factor
Configuring the Maximum Transmission Rate of Ports
Configuring Ports as Edge Ports
Configuring Path Costs of Ports
Configuring Port Priority
Configuring Whether Ports Connect to Point-to-Point
Links
Configuring the Mode a Port Uses to Recognize/Send
MSTP Packets
Enabling the Output of Port State Transition Information
Enabling the MSTP Feature
1-19
Chapter 1 MSTP Configuration
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional