Link Aggregation Configuration Example - H3C S3610-28P Operation Manual

Operation Manual – Link Aggregation
H3C S3610&S5510 Series Ethernet Switches
Display detailed
information about
specified or all link
aggregation groups
Clear the statistics about
LACP for specified or all
ports

2.3 Link Aggregation Configuration Example

I. Network requirements
Device A aggregates ports Ethernet 1/0/1 through Ethernet 1/0/3 to form one link
connected to Device B and performs load sharing among these ports.
Create a tunnel service-loop group and add port Ethernet 1/0/1 to the group.
II. Network diagram
Figure 2-1 Network diagram for link aggregation configuration
III. Configuration procedure
Note:
This example only describes how to configure link aggregation on Device A. To achieve
link aggregation, do the same on Device B.
1) In manual aggregation approach
# Create manual aggregation group 1.
<DeviceA> system-view
[DeviceA] link-aggregation group 1 mode manual
# Add ports Ethernet 1/0/1 through Ethernet 1/0/3 to the group.
To do...
display link-aggregation verbose
[ agg-id ]
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
Chapter 2 Link Aggregation Configuration
Use the command...
2-5
Remarks
Available in any
view
Available in user
view