H3C S3610-28P Operation Manual page 52

Operation Manual – Login
H3C S3610&S5510 Series Ethernet Switches
Set the history command
buffer size
Set the timeout time of the
VTY user interface
Note that if you configure not to authenticate the users, the command level available to
users logging into a switch depends on both the authentication-mode none command
and the user privilege level level command, as listed in
Table 3-4 Determine the command level when users logging into switches are not
authenticated
Authenticatio
n mode
None
(authentication
-mode none)
3.2.2 Configuration Example
I. Network requirements
Assume that you are a level 3 AUX user and want to perform the following configuration
for Telnet users logging into VTY 0:
To do...
history-command
max-size value
idle-timeout minutes
[ seconds ]
Scenario
User type
VTY users
Chapter 3 Logging in Through Telnet
Use the command...
Command
The user privilege level level
command not executed
The user privilege level
level command already
executed
3-5
Remarks
Optional
The default history
command buffer size is
10. That is, a history
command buffer can store
up to 10 commands by
default.
Optional
The default timeout time
of a user interface is 10
minutes.
With the timeout time
being 10 minutes, the
connection to a user
interface is terminated if
no operation is performed
in the user interface within
10 minutes.
You can use the
idle-timeout 0 command
to disable the timeout
function.
Table 3-4.
Command
level
Level 0
Determined
by the level
argument