Chapter 1 Link Aggregation Configuration Commands; Debugging Lacp Packet; Debugging Lacp State - H3C S9500 Series Command Manual

Command Manual – Link Aggregation Configuration
H3C S9500 Series Routing Switches
Chapter 1 Link Aggregation Configuration
1.1 Link Aggregation Configuration Commands

1.1.1 debugging lacp packet

Syntax
debugging lacp packet [ interface interface-type interface-number [ to interface-type
interface-number ] ]
undo debugging lacp packet [ interface interface-type interface-number [ to
interface-type interface-number ] ]
View
System view
Parameters
interface interface-type interface-number [ to interface-type interface-number ]:
Specifies a port or ports. The command without the parameter to specifies one port,
while the command with the parameter to specifies several contiguous ports.
interface-type indicates port type. interface-number indicates port number.
Description
Use the debugging lacp packet command to enable LACP packet debugging for the
port. If you do not specify a port, the command enables packet debugging on all
LACP-enabled ports.
Use the undo debugging lacp packet command to disable LACP packet debugging
for the port.
Examples
# Enable LACP packet debugging for Ethernet port Ethernet 1/1/1.
<H3C> debugging lacp packet interface ethernet1/1/1

1.1.2 debugging lacp state

Syntax
debugging lacp state [ interface interface-type interface-number [ to interface-type
interface-number ] ] { { actor-churn | mux | partner-churn | ptx | rx } * | all }
Commands
1-1
Chapter 1 Link Aggregation Configuration
Commands