H3C S3610-28P Operation Manual page 245

Operation Manual – MSTP
H3C S3610&S5510 Series Ethernet Switches
STP-compatible mode. In this case, you can perform an mCheck operation to force the
port to migrate to the MSTP (or RSTP) mode.
You can perform mCheck on a port through two approaches, which lead to the same
result.
1.5.1 Configuration Prerequisites
MSTP has been correctly configured on the device.
1.5.2 Configuration Procedure
I. Performing mCheck globally
Follow these steps to perform global mCheck:
Enter system view
Perform mCheck
II. Performing mCheck in Ethernet interface view
Follow these steps to perform mCheck in Ethernet interface view:
Enter system view
Enter Ethernet interface
view
Perform mCheck
Caution:
The stp mcheck command is meaningful only when the device works in the MSTP (or
RSTP) mode, not in the STP-compatible mode.
1.5.3 Configuration Example
# Perform mCheck on port Ethernet 1/0/1.
1) Method 1: Perform mCheck globally.
<Sysname> system-view
[Sysname] stp mcheck
To do...
system-view
stp mcheck
To do...
system-view
interface interface-type
interface-number
stp mcheck
Use the command...
Use the command...
1-39
Chapter 1 MSTP Configuration
Remarks
—
Required
Remarks
—
—
Required