Configuring Isatap Tunnel - H3C S3610-28P Operation Manual

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms

3.6 Configuring ISATAP Tunnel

3.6.1 Configuration Prerequisites
IP addresses are configured for interfaces such as VLAN interface, and loopback
interface on the device. Such an interface can serve as the source interface of a tunnel
to ensure that the tunnel destination address is reachable.
3.6.2 Configuration Procedure
Follow these steps to configure an ISATAP tunnel:
Enter system view
Enable IPv6
Create a tunnel interface and
enter tunnel interface view
Configure an
IPv6 address
for the tunnel
interface
Disable the RA message
suppression
To do...
Configure an
IPv6 global
unicast
address or
site-local
address
Configure an
IPv6 link-local
address
3-21
Chapter 3 Tunneling Configuration
Use the command...
system-view
ipv6
interface tunnel
number
ipv6 address
{ ipv6-address
prefix-length |
ipv6-address/prefix-leng
th }
ipv6 address
ipv6-address/prefix-leng
th eui-64
ipv6 address auto
link-local
ipv6 address
ipv6-address link-local
undo ipv6 nd ra halt
Remarks
—
Required
By default, the IPv6
forwarding function
is disabled.
Required
By default, there is
no tunnel interface
on the device.
Required.
Use either
command.
By default, no IPv6
global unicast
address is
configured for the
tunnel interface.
Optional
By default, a
link-local address
will automatically be
generated when an
IPv6 global unicast
address or link-local
address is
configured.
Required
Enabled by default.