Qinq Configuration Example - H3C S3610-28P Operation Manual

Operation Manual – QinQ-BPDU Tunneling
H3C S3610&S5510 Series Ethernet Switches
Note:
You cannot modify an existing MAC address synchronization rule. To do that, you
must remove the rule and then create a new one.
If you synchronize MAC addresses of the same source VLAN to different destination
VLANs through configuring multiple MAC address synchronization rules, the
destination VLANs will be the set of all destination VLANs specified in these rules. It
is the same case for synchronizing MAC addresses of different source VLANs to the
same destination VLAN through configuring multiple rules.
1.5 Configuring the TPID to Be Used in the Outer Tag
Follow these steps to configure the TPID value a port or a group of ports:
To do...
Enter system view
Enter
Ethernet
port view
or port
group
view
Configure the TPID
value to be used in
the outer tag

1.6 QinQ Configuration Example

I. Network requirements
Provider A and Provider B are service provider network access devices.
Customer A, Customer B and Customer C are customer network access devices.
Provider A and Provider B are interconnected through a configured trunk port.
Provider A belongs to VLAN 1000 of the service provider network, and Provider B
belongs to VLAN 2000 of the service provider network.
Third-party devices are deployed between Provider A and Provider B, with a TPID
value of 0x8200.
After configuration, the network should satisfy the following requirement:
Use the command...
system-view
Enter
interface interface-type
Ethernet
interface-number
port view
Enter
port-group { manual
interface
port-group-name |
group
aggregation agg-id }
view
qinq ethernet-type
hex-value
1-6
Chapter 1 QinQ Configuration
Remarks
—
Required
Use either command.
Configurations made in
Ethernet port view will take
effect on the current port
only; configurations made
in port group view will take
effect on all ports in the port
group.
Optional
0x8100 by default