Controlling Telnet Users - H3C S3610-28P Operation Manual

Operation Manual – Login
H3C S3610&S5510 Series Ethernet Switches
Chapter 8 Controlling Login Users
8.1 Introduction
A switch provides ways to control different types of login users, as listed in
Table 8-1 Ways to control different types of login users
Login mode
Telnet
SNMP
WEB

8.2 Controlling Telnet Users

8.2.1 Prerequisites
The controlling policy against Telnet users is determined, including the source and
destination IP addresses to be controlled and the controlling actions (permitting or
denying).
8.2.2 Controlling Telnet Users by Source IP Addresses
Controlling Telnet users by source IP addresses is achieved by applying basic ACLs,
which are numbered from 2000 to 2999.
Control method
By source IP
addresses
By source and
destination IP
addresses
By source MAC
addresses
By source IP
addresses
By source IP
addresses
Disconnect Web
users by force
8-1
Chapter 8 Controlling Login Users
Implementation
Section
Through basic
Telnet Users by Source IP
ACLs
Addresses".
Section
Through Telnet Users by Source
advanced ACLs and Destination IP
Addresses".
Section
Through Layer 2
Telnet Users by Source
ACLs
MAC
Section
Through basic Network Management
ACLs Users by Source IP
Addresses"
Section
Through basic
Web Users by Source IP
ACLs
Addresses"
By executing Section
commands in "Disconnecting a Web
CLI User by
Table 8-1.
Related section
8.2.2 "Controlling
8.2.3 "Controlling
8.2.4 "Controlling
Addresses"
8.3.2 "Controlling
8.4.2 "Controlling
8.4.3
Force".