H3C S3610-28P Operation Manual page 224

Operation Manual – MSTP
H3C S3610&S5510 Series Ethernet Switches
Root guard
BPDU guard
Loop guard
TC-BPDU guard
1.1.3 Protocols and Standards
MSTP is documented in:
IEEE 802.1d: Spanning Tree Protocol
IEEE 802.1w: Rapid Spanning Tree Protocol
IEEE 802.1s: Multiple Spanning Tree Protocol
1.2 Configuration Task List
Before configuring MSTP, you need to know the position of each device in each MST
instance: root bridge or leave node. In each instance, one, and only one device acts as
the root bridge, while all others as leaf nodes.
Complete these tasks to configure MSTP:
Configuring
the Root
Bridge
Task
Configuring an MST Region
Specifying the Root Bridge or a Secondary Root Bridge
Configuring the Work Mode of MSTP Device
Configuring the Priority of the Current Device
Configuring the Maximum Hops of an MST Region
Configuring the Network Diameter of a Switched Network
Configuring Timers of MSTP
Configuring the Timeout Factor
Configuring the Maximum Transmission Rate of Ports
Configuring Ports as Edge Ports
Configuring Whether Ports Connect to Point-to-Point Links
Configuring the Mode a Port Uses to Recognize/Send
MSTP Packets
Enabling the Output of Port State Transition Information
Enabling the MSTP Feature
1-18
Chapter 1 MSTP Configuration
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Required