H3C S3610-28P Operation Manual page 39

Operation Manual – Login
H3C S3610&S5510 Series Ethernet Switches
To do...
Define a shortcut key
for aborting tasks
Make terminal
services available to
the user interface
Set the maximum
number of lines the
screen can contain
Set history command
buffer size
Set the timeout time
for the user interface
Note that if you configure to authenticate the users in the password mode, the
command level available to users logging into a switch depends on both the
authentication-mode password and the user privilege level level command, as
listed in the following table.
Table 2-5 Determine the command level (B)
Authentication
Local authentication
(authentication-mod
e password)
Use the command...
escape-key { default |
character }
shell
screen-length
screen-length
history-command
max-size value
idle-timeout minutes
[ seconds ]
Scenario
User type
mode
Users logging
into the AUX
user interface
Chapter 2 Logging in Through the Console Port
Optional
The default shortcut key
combination for aborting tasks is <
Ctrl+C >.
Optional
By default, terminal services are
available in all user interfaces.
Optional
By default, the screen can contain
up to 24 lines.
You can use the screen-length 0
command to disable the function
to display information in pages.
Optional
The default history command
buffer size is 10. That is, a history
command buffer can store up to
10 commands by default.
Optional
The default timeout time of a user
interface is 10 minutes.
With the timeout time being 10
minutes, the connection to a user
interface is terminated if no
operation is performed in the user
interface within 10 minutes.
You can use the idle-timeout 0
command to disable the timeout
function.
Command
The user privilege level
level command not
executed
2-11
Remarks
Command
level
Level 3