H3C S3610-28P Operation Manual page 311

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
3.4.2 Configuration Procedure
Table 3-1 Follow these steps to configure an automatic IPv4-compatible IPv6 tunnel
Enter system view
Enable the IPv6 packet
forwarding function
Create a tunnel interface and
enter tunnel interface view
Configure an
IPv6 address
for the tunnel
interface
Configure an automatic
IPv4-compatible IPv6 tunnel
To do...
Configure an
IPv6 link-local
address
Configure a
local IPv6
address or
global unicast
address
Chapter 3 Tunneling Configuration
Use the command...
system-view
ipv6
interface Tunnel number
ipv6 address auto
link-local
ipv6 address ipv6-address
link-local
ipv6 address { ipv6-address
prefix-length |
ipv6-address/prefix-length }
ipv6 address
ipv6-address/prefix-length
eui-64
tunnel-protocol ipv6-ipv4
auto-tunnel
3-11
Remarks
—
Required
By default, the
IPv6 packet
forwarding
function is
disabled.
Required
By default, there
is no tunnel
interface on the
device.
Optional.
By default, after
an interface is
configured with a
local IPv6
address or global
unicast address,
the link-local
address is
generated
automatically.
Either is required.
By default, no
IPv6 global
unicast address
or local IPv6
address is
configured for a
tunnel interface.
Required
By default, the
tunnel is a
manually
configured tunnel.
The same tunnel
mode should be
configured at both
ends of the
tunnel.
Otherwise, packet
delivery will fail.