Ipv6 Basics Configuration Task List; Configuring Basic Ipv6 Functions - H3C S3610-28P Operation Manual

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
RFC 2375: IPv6 Multicast Address Assignments
RFC 2460: Internet Protocol, Version 6 (IPv6) Specification.
RFC 2461: Neighbor Discovery for IP Version 6 (IPv6)
RFC 2462: IPv6 Stateless Address Autoconfiguration
RFC 2463: Internet Control Message Protocol (ICMPv6) for the Internet Protocol
Version 6 (IPv6) Specification
RFC 2464: Transmission of IPv6 Packets over Ethernet Networks
RFC 2526: Reserved IPv6 Subnet Anycast Addresses
RFC 3307: Allocation Guidelines for IPv6 Multicast Addresses
RFC 3513: Internet Protocol Version 6 (IPv6) Addressing Architecture
RFC 3596: DNS Extensions to Support IP Version 6

1.2 IPv6 Basics Configuration Task List

Complete the following tasks to perform IPv6 basics configuration:

Configuring Basic IPv6 Functions

Configuring IPv6 NDP
Configuring PMTU Discovery
Configuring IPv6 TCP Properties
Configuring IPv6 FIB-Based Forwarding
Configuring ICMPv6 Packet Sending
Configuring IPv6 DNS
1.3 Configuring Basic IPv6 Functions
1.3.1 Enabling the IPv6 Packet Forwarding Function
Before IPv6-related configurations, you must enable the IPv6 packet forwarding
function. Otherwise, an interface cannot forward IPv6 packets even if an IPv6 address
is configured, resulting in communication failures in the IPv6 network.
Follow these steps to enable the IPv6 packet forwarding function:
Enter system view
Enable the IPv6 packet
forwarding function
Task
To do...
system-view
ipv6
Chapter 1 IPv6 Basics Configuration
Required
Optional
Optional
Optional
Optional
Optional
Optional
Use the command...
1-12
Remarks
Remarks
—
Required
Disabled by default.