H3C S3610-28P Operation Manual page 295

Operation Manual – IPv6
H3C S3610&S5510 Series Ethernet Switches
FF02::1:FF49:8048
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# Display the IPv6 information of the interface on Switch B.
[SwitchB-Vlan-interface2] display ipv6 interface vlan-interface 2
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::20F:E2FF:FE00:1
Global unicast address(es):
2001::20F:E2FF:FE00:1, subnet is 2001::/64
3001::2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:2
FF02::1:FF00:1
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# From Switch A, ping the link-local address, EUI-64 address, and aggregatable global
unicast address respectively. If the configurations are correct, the three types of IPv6
addresses above can be pinged.
Caution:
When you ping a link-local address, you should use the "–i" parameter to specify an
interface for the link-local address.
[SwitchA-Vlan-interface2] ping ipv6 FE80::20F:E2FF:FE00:1 -i vlan-interface2
PING FE80::20F:E2FF:FE00:1 : 56
Reply from FE80::20F:E2FF:FE00:1
bytes=56 Sequence=1 hop limit=255
Chapter 1 IPv6 Basics Configuration
data bytes, press CTRL_C to break
time = 80 ms
1-27