Configuring A Port Group - H3C S3610-28P Operation Manual

Operation Manual – Port Correlation Configuration
H3C S3610&S5510 Series Ethernet Switches

1.1.5 Configuring a Port Group

To make the configuration task easier for users, certain devices allow users to configure
on a single port as well as on multiple ports in a port group. In port group view, the user
only needs to input the configuration command once on one port and that configuration
will apply to all ports in the port group. This effectively reduces redundant
configurations.
A Port group belongs to one of the following two categories:
Manual port group: manually created by users. Multiple Ethernet ports can be
added to the same port group;
Dynamic port group: dynamically created by system, currently mainly applied in
link aggregation port groups. A link aggregation port group is automatically
created together with the creation of a link aggregation group and cannot be
created by users through command line input. Adding or deleting of ports in a link
aggregation port group can only be achieved through operations on the link
aggregation group.
Follow these steps to enter port group view:
Enter system view
Enter port
group
view
Follow these steps to configure a manual port group:
Enter system view
Create a manual port
group
Add Ethernet ports to the
manual port group
Note:
For information about link aggregation port group, refer to Link Aggregation
Configuration.
To do...
Enter manual port group
view
Enter aggregation port
group view
To do...
system-view
port-group manual
port-group-name
group-member
interface-list
Chapter 1 Ethernet Port Configuration
Use the command...
system-view
port-group manual
port-group-name
port-group
aggregation agg-id
Use the command...
1-5
Remarks
—
—
—
Remarks
—
Required
This operation also leads
you to manual port group
view.
Required