Sony MVS-8000X User Manual page 1297

Multi-format production switcher processor with ccp-8000 series center control panel volume 1
Hide thumbs Also See for MVS-8000X:
Table of Contents

Advertisement

Icon
Title
Message
Restore
Restoring...
Data
Success!!
Recovery binary on the USB
storage device is not found.
Restore
Failure.
Data
Copying recovery data hasn't
finished.
Set Time/
Error: Wrong Format.
Date
Trim
The Start TC or Stop TC is not
properly set.
This file is locked.
This file is using for playback.
Warning
No Switcher information
available.
Please confirm "Network
Configuration" on Page 7311.
Description
Appears while restoring recovery data using
a)
Menu 9999.
Appears when recovery data has been
successfully restored using Menu 9999.
Recovery data for restoring using Menu 9999
cannot be found on the memory card. Check
that the recovery data has been correctly
copied to the memory card, and restart the
a)
system to retry.
Restoring recovery data using Menu 9999
failed. Check that the recovery data has been
correctly copied to the memory card, and
restart the system to retry.
7317: Engineering Setup >System
>Maintenance
In the above menu, an incorrect date and time
was specified. Specify the date and time
correctly.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if neither Start TC not Stop
TC is set.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the interval between Start
TC (or Clip Begin) and Stop TC (or Clip End) is
the entire clip.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the Start TC (or Clip Begin)
value is greater than the Stop TC (or Clip End)
value.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the file is locked.
2522:Frame Memory >Clip >Play
In the above menu, when [Trim] is pressed, this
message appears if the file is being played
back.
When starting up the menu system, the
switcher is not present in the system
information. Check the Data LAN connections,
and in Menu 7311: Engineering Setup >System
>Network Config, retry [Auto Config].
a)
a)
1297
Error Messages

Advertisement

Table of Contents
loading

Table of Contents