Sony MVS-8000X User Manual page 1292

Icon Title
GPI
Output
HDD
Format
HDD
Format
Import
Initial
Read
Install
1292
Error Messages
Message
Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Failure.
HDD device is busy.
In order to complete HDD
format, System needs to be
restarted and formatted again.
System will be restarted, then
please execute HDD format
again.
Success!!
System will be restarted.
Success!!
But some partitions cannot be
created because the capacity
of the HDD is not enough.
Cannot create the clip file,
because the number of
selected files is insufficient.
Initializing now...
No Task.
Select a package on the list.
Description
7325.3/4: Engineering Setup >Panel >Device
Interface >GPI Output
7337.2/3: Engineering Setup >Switcher
>Device Interface >GPI Output
7337.4/5: Engineering Setup >Switcher
>Device Interface >GPI Output
7344.3/4: Engineering Setup >DME >Device
Interface >DME1 GPI Output
7344.7/8: Engineering Setup >DME >Device
Interface >DME2 GPI Output
7354/7354.1: Engineering Setup >DCU >GPI
Output Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
7317: Engineering Setup >System
>Maintenance
In the above menu, the hard disk formatting
procedure failed.
If the hard disk is functioning correctly, or in
some cases when there is damage to the disk,
it may not be possible to format the disk
correctly in a single attempt. In such cases, it is
necessary to restart the system, and then carry
out formatting again.
Press [OK] to restart the system.
7317: Engineering Setup >System
>Maintenance
In the above menu, the hard disk formatting
procedure completed successfully.
Press [OK] to restart the system.
7317: Engineering Setup >System
>Maintenance
In the above menu, hard disk formatting was
completed normally, but because of insufficient
hard disk capacity, only the possible number of
partitions were created.
7162:File >All, External File >Import/Export
In the above menu, when importing a clip file,
this message appears if insufficient files are
selected to make up the clip.
This popup message appears during menu
startup, while system information is being read
in.
7316.10: Engineering Setup >System >Install/
Unit Config >Install
In the above menu, the package for installation
was not selected. Select a package to be
installed.