Sony MVS-8000X User Manual page 1291

Icon Title Message
Extraction Clip register error (–14).
Can't extract pair clip (–15).
Clip id not enough (–50).
Still frame on FM 2nd board (–
51).
Clip frame number can't be
ODD in 720P format (–9).
File Frame Some requests are skipped.
Memory Following operation is not
permitted.
— Loading that will cause
duplicate register name.
File Open ERROR (01)
Status
ERROR (02)
ERROR (FF): No target device
has been assigned
GPI Input Please set Target.
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
Description
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if the specified
register number data cannot be processed
(internal processing error).
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if an attempt is
made to extract a pair clip.
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if there are 100
clips or more.
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if a still image
was extracted from an external clip.
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if an odd
number of clips are extracted (720P format
only).
7151: File >Frame Memory
7162: File >All, External File >Import/Export
In the above menu, an attempt was made to
load a file of a name already existing in the
register.
533X: Device >DDR/VTR
When an error is returned from the DDR/VTR,
one of these messages appears, depending on
the error number.
Use Menu 7355: Engineering Setup >DCU
>Serial Port Assign or Menu 7325.4:
Engineering Setup >Panel >Device Interface
>Serial Port/MPE Assign to check the device
settings.
7325.1/2: Engineering Setup >Panel >Device
Interface >GPI Input
7344.1/2: Engineering Setup >DME >Device
Interface >DME1 GPI Input
7344.5/6: Engineering Setup >DME >Device
Interface >DME2 GPI Input
7352/7352.1: Engineering Setup >DCU >GPI
Input Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
1291
Error Messages