Mmc Programs (In Numerical Order) - Samsung DCS Programming Manual

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
Part 3. MMC Programs
This part contains all the MMC programs provided for your telephone system, presented in
numerical order. The following information should help you when using MMCs.
• The procedure described for a particular MMC may be slightly different on your sys-
tem and some LCD displays may not be exactly as shown. For example, port num-
bers may be different for the system you are programming. Refer to section
tem Configuration: Quick Reference
• 408 and 408i systems employ 2-digit extension and group numbers by default, unlike
other systems which use 3- or 4-digit numbers by default. These dialling number
plans can be changed by the system installer using MMC 724, so make sure you are
aware of all dialling plans for your system.
• To identify which MMCs apply to your system, either refer to the
ginning of this manual, or locate the relevant MMC page (below) and refer to the
header check box beneath the title.
• The procedure described for each MMC assumes you are the installer or system
administrator with system-wide access via a passcode. However, MMCs 100–125
are also accessible to individual keyset users. If you are programming your own key-
set at Station level, the procedure may be different and you should also refer to your
Samsung Keyset User Guide for more information.
Always remember that the displays shown for each MMC in this manual are
provided as examples, and should be used for guidance only.
Make sure the correct country is first selected in
before carrying out any other programming.
in Part 2 for the relevant options for your system.
3–1
MMC PROGRAMS
FEBRUARY 2004
2.3 Sys-
MMC lists at the be-
MMC 812