Samsung DCS Programming Manual page 281

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
If changing feature codes using the FEAT DIAL NO option, you can use the VOLUME
keys to scroll through selectable features. Features can also be entered via the dial key-
pad. For example, for OHVA, the number 6 would be pressed three times. If Block Code
is required, press 2 twice for BARGE and then use the VOLUME UP key to select
BLOCK.
The example shown below describes the use of the FEAT DIAL NO option.
ACTION
1. Open programming and select 724
Display shows (e.g. for Compact II)
2. Enter option number 0-8 (e.g. FEAT DIAL NO.)
OR
Press VOLUME keys to make selection and press
RIGHT soft key.
3. Use dial keypad to select feature (e.g. DICT)
OR
Press VOLUME keys to make selection and press
RIGHT soft key to advance cursor
4. Enter digits (e.g., 68)
5. Press LEFT soft key to enter change and continue
to make changes
OR
Press RIGHT soft key to enter and return to step 2
If an error message appears indicating duplication
of access code, enter 1 for YES (change) OR 0 for
NO (no change)
6. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next MMC
MMC 724 (Page 2 of 3)
MMC PROGRAMS
FEBRUARY 2004
DISPLAY
STN DIAL NUMBER
BASE01:201 →
FEAT DIAL NUMBER
ABAND: 64→
FEAT DIAL NUMBER
DICT :NONE→_
FEAT DIAL NUMBER
DICT :NONE→68
SAME DIAL EXIST
CHANGE? Y:1,N:0