Samsung DCS Programming Manual page 343

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 810
FOR: DCS CI CII
Purpose: Used only in the event that all data processing needs to be stopped in either a
single cabinet or slot, or in the entire system. The procedure differs slightly between sys-
tems.
Note: You do not need to enable system programming (MMC 800) in order to run this program but
you will still require the technician's passcode
DCS, iDCS500 & OS500 PROCEDURE
ACTION
1. Open programming and select 810
Display shows
2. Enter cabinet number
OR
Press VOLUME keys to make selection and press
RIGHT soft key to advance cursor
OR
Select all cabinets and all slots
(and go to step 4)
3. Enter slot number
OR
Press VOLUME keys to make selection and press
RIGHT soft key to advance cursor
4. Enter 1 for HALT or 0 to PROC
OR
Press VOLUME keys to make selection and press
RIGHT soft key to enter data and return to step 2
5. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
816 iDCS100 iDCS500
(see section 1.5.2)
MMC 810 (Page 1 of 2)
HALT PROCESSING
OS500
.
DISPLAY
HALT/PROCESSING
C:ALL S:ALL→PROC
HALT/PROCESSING
C:3
HALT/PROCESSING
C:ALL S:ALL→PROC
HALT/PROCESSING
C:3
HALT/PROCESSING
C:3
MMC PROGRAMS
FEBRUARY 2004
S:ALL→PROC
S:5 →PROC
S:5 →HALT