Samsung DCS Programming Manual page 371

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 834
FOR: iDCS100
Purpose: Provides various VoIP support options. The options set in this MMC are sys-
tem wide.
iDCS ITM3 Card & Procedure
H.323 FAST SETUP
GATEWAY CALL ID
BILLING TYPE
CALLER ID TYPE
INCOMING CHANNEL
DTMF GENERATION
FAX SIGNAL TYPE
SWITCH TO H.245
DEFAULT DIL NO.
SIGNALLING PORT
STATUS PORT
WCS PORT
SIGK ACCESS PORT
MAKE DEFAULT DB
EARLY H245 MODE
RING BACK TONE
Q931 NO ANS TIME
ISP TYPE
FACILITY TYPE
iDCS500 OS500
Enables or disables the H.323 Fast Start call method.
A numeric entry that identifies the system via the ITM3 connection.
Maximum entry is four digits.
Standard.
This option controls the calling party identification type. There are
three possible selections: ANI which shows the calling station
number when the call is an ITM3 to ITM3 call; IP which shows the
calling ITM3 IP address; and GW (Gateway) ID which is a 4-digit
pre-programmed ID.
Selects whether the incoming channel is Sequential or Distributed.
Allows four different transport types of DTMF: In-band, Q931,
H.245 Signal, and H.245 Numeric.
Selects the facsimile standard to use when transporting faxes via
the ITM3. Selections are T.38 or the proprietary Samsung formats.
Default is T.38.
Enables switching to the H.245 protocol at the time of Fast Start
Allows programming of the default DIL number when digits are not
included on an incoming call.
Indicates the port number for H.323 signalling and sets a range of
numbers allowed by firewall equipment. The IP path or port used is
10000.
Port number for the exchange of status information between
ITM3/MGI cards. The IP path or port used in 20000.
Proprietary Samsung Web Call Service. The IP path or port used is
20010.
Samsung Internet Gatekeeper. The IP path or port used is 20020.
This option permits defaulting of the ITM3 card program parame-
ters. CAUTION: This option is system wide and defaults all ITM3
cards in the system! Card must be restarted to take affect.
Set to YES if H.323 FAST START SETUP is enabled.
Generates Ring Back tone.
0 DISABLE: Do not use Ring Back tone
1 SETUP: Use Ring Back tone when sending set-up
2 ALERT: Use Ring Back tone when receiving Alert
Timer used to disconnect call on no answer.
Used when connecting to ITSP (NORMAL / UNITEL / RUSSIA)
NORMAL / NO REQ
MMC 834 (Page 1 of 4)
VoIP OPTIONS
(Systems with ITM3 or MGI card)
MMC PROGRAMS
FEBRUARY 2004