Samsung DCS Programming Manual page 167

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
• BRI CODING
A-LAW or µ-LAW (A-LAW in UK)
• CLIP TABLE
Used to select the CLIP number to send to the network. If NONE is selected, the
trunk number set in
number entered in
here is sent to the network.
• NB TYPE
Changes the number type field of the set-up message for the CLIP number sent to
the network. Options are UNKNOWN and INT NAT (International).
Ports Programmed as "STATION" in MMC 423
Display shows "BRI-STN". Items to select include some or all of the following: CHANNEL
ANY, POWER FEED and BRI CODING.
• CHANNEL ANY
(See above.)
• POWER FEED
This field determines if power to a BRI access will be supplied (YES or NO).
• BRI CODING
A-LAW or µ-LAW (A-LAW in UK)
In BRI-STN, options DLSEND and BRI MODE are not included because the system uses
implicit data for these: enblock for DLSEND and P-MP for BRI MODE.
ACTION
1. Open programming and select 419
Display shows
2. Dial BRI trunk number (e.g. 703)
OR
Press VOLUME keys to select the port
For TRUNK ports (TRK), go to step 3.a
For STATION ports (STN), go to step 3.b
3.a Display is as shown for TRUNK ports
Use the RIGHT soft key to position the cursor un-
der CHANNEL ANY
MMC 405 (Trunk Number)
MMC 323 (Send CLIP Number)
MMC 419 (Page 2 of 3)
is sent to the network. Otherwise, the
corresponding to the number set
DISPLAY
[701] BRI-TRK
CHANNEL ANY : YES
OR
[701] BRI-STN
CHANNEL ANY : YES
[703] BRI-TRK
CHANNEL ANY : YES
MMC PROGRAMS
FEBRUARY 2004