Samsung DCS Programming Manual page 398

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 852
FOR: iDCS100 iDCS500
Purpose: Assigns system alarms to ring and display on stations that have a System
Alarm key programmed in
iDCS500 and OS500 systems (tenants 1 and 2). Alarms not programmed to report to the
System Alarm key will still be retained in the maintenance alarm buffer for alarm report-
ing (MMC 851). The alarm buffer holds up to 100 alarms on a First In/First Out (FIFO)
basis. Pressing the System Alarm key will silence the audible alarm until another alarm is
generated by the system. Alarm conditions that have multiple causes (e.g. E1 errors and
synchronization loss) will print all associated alarm information if an SIO port is pro-
grammed as an ALARM port in
via MMC 851.
Note: Alarm Notification Off/On (0/1) determines if the alarm provides a visual and audible notifi-
cation to the System Alarm key station(s). Pressing the System Alarm key and the ANS/RLS key
will silence the audible alarm only at the station at which these keys were pressed.
Refer to the Alarm Code Table in
numbers 01–87 respectively in MMC 852, and each is selectable ON/OFF.
ACTION
1. Open programming and select 852
Display shows
2. Press VOLUME keys to select alarm number and
press RIGHT soft key
3. Press VOLUME keys to select alarm ON/OFF (e.g.
ON) and press RIGHT soft key
4. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data:
Related Items
ASSIGN SYSTEM ALARMS
OS500
MMC 722. System Alarm key programming is tenant-wide on
MMC
MMC
All alarms OFF
MMC 501 System Timers
MMC 722 Station Key Programming
MMC 723 System Key Programming
MMC 851 Alarm Report
MMC 853 Maintenance Busy
MMC 852 (Page 1 of 1)
(iDCS systems must have a LAN interface installed.)
804. The specific fault alarm data can be displayed
851. Codes MJA01 to MNF27 are designated
DISPLAY
01:MJA01 ACT:OFF
POR Restart
01:MJA01 ACT:OFF
POR Restart
01:MJA01 ACT:ON
POR Restart
MMC PROGRAMS
FEBRUARY 2004