Samsung DCS Programming Manual page 368

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 832
FOR: iDCS100
Purpose: Sets the ITM3/MGI internal numbering plan for dialling and conversion.
ACCESS CODE
CODE LENGTH
DEL LENGTH
INSERT CODE
IP TABLE 1
IP TABLE 2
(iDCS systems)
IP START
GK USE
ACTION
1. Open programming and select 832
Display shows
2. Dial an entry number (e.g. 01)
OR
Press VOLUME keys to select and press RIGHT
soft key
3. Press RIGHT soft key and enter access code (max
8 digits) and press RIGHT soft key
4. Press VOLUME keys to select next option (Code
Length) and press RIGHT soft key
5. Enter Code Length (e.g. 8) and press RIGHT soft
key
iDCS500 OS500
Once the ITM3/MGI is accessed, the access code directs a call based on the
routing tables. An access code table references an access code. Codes are
a maximum of 8 digits. There are 63 access code entries (00–62)
This field requests the number of digits (0–8) that are expected to be re-
ceived to make up the access code
The number of digits (0–8) to delete after receiving the access code. If no
digits are deleted the access code will be sent as part of the call to the
destination to continue routing at the destination
The code to insert for routing at the destination. This can be used when dif-
ferent numbering plans exist or if a 'dial 9' access is needed to be inserted in
the dialled digits (max 8 digits)
The first table referenced for routing the access code to an IP address.
For iDCS systems: IP tables are 00–30. For OS500 systems: IP tables are
(00–62).
For iDCS systems, the second table (00–30) referenced as a look-up for an
IP address to route the call based on the access code.
This entry indicates where in a table to start looking for an IP code to associ-
ate with the access code. This can be used to manage where to start looking
for an IP address in high traffic ITM3/MGI applications. For example: if IP
address routing to the desired destination is known to be in the last 7 entries
of a table, the IP START location would be 25. IP address searching would
start at entry 25.
Connection through Gatekeeper (YES/NO). (Only applicable when GK
ROUTING is enabled in
MMC 832 (Page 1 of 2)
(Systems with ITM3 or MGI card)
MMC 836.)
DISPLAY
(00) ACCESS CODE
0
(01) ACCESS CODE
1
(01) ACCESS CODE
12345678
(01) CODE LENGTH
1
(01) CODE LENGTH
8
MMC PROGRAMS
FEBRUARY 2004
VoIP CODE