Samsung DCS Programming Manual page 190

SAMSUNG MMC PROGRAMS
COMBINED SYSTEMS PROGRAMMING MANUAL FEBRUARY 2004
PAGE TIME OUT: Controls the duration of a page announcement.
PAGE TONE: Controls the duration of tone burst heard over the page prior to the page announce-
ment.
PARK RECALL: Controls the period of time a call is parked before recalling to the call park originator.
PC-MMC LOCK: Monitors PCMMC activity, drops the link if no action is created by PCMMC and re-
turns the system to secure program status.
PERI UCD REPORT: Controls the interval between periodic UCD reports being output to the applica-
ble port.
POWER DOWN: Sets the duration of disconnect signal for VM/AA ports.
RECALL DISCONNECT: The time an attendant recall rings before being disconnected. See
ATT Re-
timer.
call
RECALL WAIT: This is the time any recall (hold or transfer) continues to recall at your station before
it recalls to the operator.
SMDR START/DP (DIAL PULSE (ROTARY)): This grace period timer starts SMDR recording for ro-
tary dialling. This timer also controls the LCD duration timer on the keysets. The duration time dis-
played and the SMDR time duration will be the same.
SMDR START/DTMF: This grace period timer starts SMDR recording for touchtone dialling. This
timer also controls the LCD duration timer on the keysets. The duration time displayed and the SMDR
time duration will be the same.
ROUTE OPTIMISE: When a call is made via Q-SIG signalling, route optimisation is activated after this
time.
SYS HOLD RECALL: Determines the time calls can be left on hold before recalling the holding sta-
tion. Setting timer to 000 means no recalling will take place.
TRANSFER RECALL: Determines the time that transferred calls ring before recalling. See
Recall
Wait timer.
TSW CONN. DELAY : On external call forward or tandem working, the time before the forward desti-
nation is connected to the external call. If this timer is very short, the caller hears ringback tone, dial
tone and ringback tone again.
UCDS AUDIO ALARM: Determines how long the longest waiting call can be held before the system
gives an audio alarm to the UCD supervisor.
UCDS VISUAL ALARM: Determines how long the longest waiting call can be held before the system
gives a visual alarm to the UCD supervisor.
VMS UCD MSG: Not used in UK/EU.
VOICE DIAL DELAY: Monitors the duration of the interaction between the main software and the
Voice Dialler card. If there is no response from the card within this time, the system decides that voice
dialling has failed (iDCS500 and OS500 systems only).
VOIP RE-ROUTE: Time allowed for the system to wait for a response to a setup message over the
VoIP network before it goes to the next route.
MMC 501 (Page 6 of 6)