Samsung DCS Programming Manual page 94

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 213
FOR: DCS CII
Purpose: Assigns a name to an alarm sensor. Names are written using the dial keypad.
Each press of a key selects a character and moves the cursor to the next position. For
example, if the sensor name is "FIRE," press the number "3" three times to get the letter
"F." Now press the number "4" three times to get the letter "I", and so on to complete the
name. Press the programmable
(Refer to section 1.5.2
Tip: When the character you want is on the same key as the previous character you typed in,
press the VOLUME UP key to move the cursor to the right, then select the character.
The # key can be used for the following special characters (in sequence of key presses):
# space &
[ ] @
ACTION
1. Open programming and select 213
Display shows (e.g. 351 for Compact II)
2. Dial ALARM (e.g., 351 or 3502)
OR
Press VOLUME key to make selection
and press RIGHT soft key to move cursor
3. Enter name using method described above and
press RIGHT soft key to return to step 2
4. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data:
Related Items:
iDCS100
"A" key
in Part 1 for key descriptions.)
! : ?
^ ( ) _
None
MMC 212 Alarm Ringing Station
MMC 213 (Page 1 of 1)
ALARM MESSAGE
to toggle between upper and lower case text.
. , % $
+ { }
DISPLAY
[351] ALARM NAME
[351] ALARM NAME
_
[351] ALARM NAME
FIRE!
MMC PROGRAMS
FEBRUARY 2004
- < > /
→
| ; "
=
`