Samsung DCS Programming Manual page 397

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
ALM CODE ALARM
MNF06 Trunk Disconnect
MNF07 Trunk Connect
MNF08 SIO TxQ Over
MNF09 SIO TxQ Under
MNF10 E1 Out Of Srv
MNF11 E1 In Service
MNF12 SIO Out
MNF13 SIO In
MNF14 TODC Error
MNF15 TSW Over Alarm
MNF16 PSU Alarm
MNF17 PSU Alarm Rec
MNF18 SLI Fault
MNF19 SLI Recovery
MNF20 PSUB Alarm
MNF21 DSS Alarm
MNF22 Phone Disconnect
MNF23 Phone Connect
MNF24 NOT USED
MNF25 NOT USED
MNF26 SIO RxQ Over
MNF27 SIO RxQ Under
Out of service trunk detected via seizure of trunk. External
seizure test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Out of service trunk recovered via seizure of trunk External
seizure test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
SIO Tx Queue full error has occurred in the MCP.
Alarm Data = SIO number (SIO:x)
SIO Tx Queue under error has occurred in the MCP.
Alarm Data = SIO number (SIO:x)
E1 Digital line status has been changed to out of service.
Alarm Data = Cabinet, Slot (Cx-Syy)
E1 Digital line has been restored to normal service.
Alarm Data = Cabinet,Slot (Cx-Syy)
IO port has lost DTR
Alarm Data = SIO number (SIO:x)
IO port has regained DTR.
Alarm Data = SIO 1 through 3
Time of Day Clock in the MCP in error.
TSW has been requested to exceed the capacity of available
time slots. Maximum 192 per cabinet.
Alarm Data = Cabinet, Slot (Cx-Syy)
Indicates there are over 56 ports in a cabinet with a single PSU
and more power is required.
Alarm Data = Cabinet, Slot (Cx-Syy)
A second PSU has been recognised when added after alarm
condition of:
Alarm Data = Cabinet, Slot (Cx-Syy)
An SLI card has been detected as out of service via an internal
CODEC test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
An SLI card detected as out of service has been detected as
recovered and is in service via internal CODEC test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Indicates there are over 120 ports in a cabinet with two PSUs.
Alarm Data = Cabinet, Slot (Cx-Syy)
System capacity of 64-button DSS modules has been exceeded.
Indicates the keyset is disconnected.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Indicates the keyset is connected.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
FUTURE USE
FUTURE USE
SIO Rx Queue full error has occurred in the MCP.
Alarm Data = SIO number (SIO:x)
SIO Rx Queue under error has occurred in the MCP.
Alarm Data = SIO number (SIO:x)
MMC 851 (Page 5 of 5)
MMC PROGRAMS
FEBRUARY 2004
DEFINITION