Programming Procedures; Precautions When Programming - Samsung DCS Programming Manual

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
When installing and programming a 'default' system for the first time
You should select the correct software version for your country (e.g. "UK") before you
can do any other programming via either a keyphone (KMMC programming) or a PC
(PCMMC programming). To select the country:
1. Press the Transfer / TRSF key.
2. Enter 800 followed by the default passcode (4321)
The system sounds a warning and displays on the keyset:
Use the VOLUME Up/Down keys to select the country and press the RIGHT soft key.
The keyset displays:
Use the VOLUME Up/Down keys to select YES and press the RIGHT soft key. When
defaulted to the correct version, you can open programming (see 1.6.2). The country
version selected can be changed in

1.6 Programming Procedures

1.6.1 Precautions When Programming

• The keyset must be on-hook (handset down) to allow programming.
• Programming can be done on any digital keyset with an LCD.
• Programming is available only on digital telephones (not analogue ones).
• If 'INVALID DATA' appears in the LCD while programming, you should re-enter the
correct data.
• When you have successfully completed an entry, the display automatically changes
for the next step.
• Programming halts if you have not pressed a key for a certain period of time. This is
30 seconds by default, but can be changed in
• Programming halts if you pick up the handset while programming.
• If you pick up the handset while programming, or the telephone plug is pulled out,
any new data shown in the LCD are saved.
I
MPORTANT
DEFAULTING SYSTM
ARE YOU SURE?NO
MMC 812 (Select Country).
1–6
ENABLE TECH. PROG
SELECT COUNTRY
MMC 501 (KMMC Lock Out timer).
INTRODUCTION
FEBRUARY 2004