Introduction To Programming; Using This Manual; Systems Covered In This Manual - Samsung DCS Programming Manual

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
Part 1. Introduction to Programming
It is strongly recommended that you read the whole of this part of the manual as it pro-
vides a useful overview of MMC programming procedures.

1.1 Using this Manual

•
For a comprehensive list of available MMCs in numerical order, see
Part 2.
•
For quick reference, Part 2 also provides a
each MMC. "Y" (Yes) in the appropriate column indicates that an MMC can be used
for that system. The table also lists default settings for each MMC (for the UK only).
•
To begin programming, refer to the appropriate MMC(s) in
an MMC, check the header bar. This also tells you if the program is available on your
system.
•
To quickly check the allowed configuration settings for your system—for example, the
number of trunk group members, card port numbers, and so on—see
System Configuration: Quick Reference,

1.2 Systems Covered in this Manual

This manual describes the MMC programming required for the Samsung telephone sys-
tems listed in the following table. The table includes the name by which each system is
referred to in this manual (to avoid using the full name each time), and any other relevant
details.
Telephone System
DCS
DCS Compact
DCS Compact II
DCS-816
DCS-408
DCS-408i
iDCS500 (L and M versions)
iDCS100
OfficeServ500 (L, M and S
versions)
table
in Part 2.
Referred Name
DCS
Compact I (or CI)
Compact II (or CII)
816
408
408i
iDCS500
iDCS100
OS500
1–1
FEBRUARY 2004
indicating which systems can use
Part 3. When you select
Comment
Unless otherwise stated, references to
"DCS" in this manual include Compact I
systems.
See comment above.
Where programming requirements are
i
the same, the term "
this manual to include both
i
and DCS500 systems. The term
i
" DCS500" includes both 'L' and 'M'
versions, unless stated otherwise.
The term "OS500" includes 'L', 'M' and
'S' versions, unless stated otherwise.
INTRODUCTION
section 2.1 in
section 2.3,
DCS" is used in
i
DCS100