Samsung DCS Programming Manual page 198

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 507
FOR: iDCS100
Purpose: Programs Ring Plan time settings. Ring Plans provide six separate ringing
destinations (1–6) based on day of the week and time of day. The start time within a plan
is the time the system will switch from the previous ringing destination to the one in this
plan. The end time within a plan is the time the system will switch from this plan to the
previous plan. If a ring plan has no time entry, the system defaults to ring plan 1. The
ring plans correlate with all MMCs that program ring or termination destinations and sta-
tion and trunk COS
It is helpful to also have a dedicated Ring Plan (RP) and Ring Time Override (RTO) key
programmed on a keyset so the ring plan can be manually changed if needed. The RP
key provides a temporary override until the next programmed ring plan start time. The
RTO key provides a permanent override until the key is pressed again to disable the
override. (Refer to either
Programming.) A passcode is required to use these keys (see
When programming ring plans for any given day, it is important to remember that:
•
they must be programmed in sequence (1, 2, 3, 4, 5, 6);
•
a ring plan cannot be skipped (e.g. you cannot program 1, 2, 4, etc);
•
a higher numbered plan cannot have a start time earlier than a lower numbered
plan;
•
ring plan 1 is the default plan.
Example
You might enter the following ring plans for Monday (in 24-hour clock format, e.g. 2200 is
10.00pm).
RING PLAN
(MON: 1)
(MON: 2)
(MON: 3)
(MON: 4)
(MON: 5)
(MON: 6)
The system will stay in the last active ring plan from the previous day until the end time
which is 23:59. Monday starts ring plan 1 at 00:00 (midnight). The system will stay in
ring plan 1 until 08:00 and will stay in Ring Plan 2 until Ring Plan 3 starts (10.00). As
each ring plan starts it will override the previous ring plan. If a ring plan ends and there
are no subsequent ring plans, the system will default to the ring plan with an end time
that extends past the expired ring plan time.
ASSIGN RING PLAN TIME
iDCS500 OS500
MMC 722, Station Key
START TIME
ST: 0000
ST: 0800
ST: 1000
ST: 1200
ST: 1300
ST: 1400
MMC 507 [iDCS/OS500] (Page 1 of 2)
For MMC 507 Assign Auto Night
Programming, or
END TIME
END: 23:59
END: 2200
END: 2000
END: 1800
END: 1600
END: 1500
MMC PROGRAMS
FEBRUARY 2004
Time, see below
MMC 723, System Key
MMC 202).