Samsung DCS Programming Manual page 44

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 105
FOR:
Purpose: Programs personal speed dial numbers for stations. This may be particularly
useful for single line telephones which are more difficult to program by the station user.
By default, each station has one block of speed dial locations or "bins" (numbered 00–
09) assigned to it. One block can hold up to 10 numbers. However, each station can
have up to five blocks of speed dial locations assigned to it—in
Block—giving a total of 50 numbers (00–49).
Each speed dial may contain a trunk or trunk group access code (e.g. 9) followed by a
separator (–) and up to 24 digits to be dialled. These dialled digits can be 0–9,
the system recognises a valid trunk or trunk group access number, it will automatically
insert the separator.
The following keys can also be used:
"B" Insert a flash code "F"
"C" Insert a pause code "P"
"D" Insert a pulse/tone conversion code "C"
"E" Mask/unmask following digits (shows as "[" or "]")
"F" Enter name for speed dial bin (see
(Refer to section 1.5.2
ACTION
1. Open programming and select 105
Display shows
2. Dial station number (e.g. 205)
OR
Press VOLUME keys to select station and press
RIGHT soft key to move cursor
If selected station has no speed dial blocks as-
signed, the display will be as shown and a new
station may be selected.
3. Enter speed dial number (e.g., 05)
OR
Press VOLUME keys to select location and press
RIGHT soft key to move cursor
4. Enter trunk access code (e.g., 9) followed by the
number to be dialled (e.g., 08104264100)
If you make an error, press the HOLD key to clear
an entire entry or use the VOLUME (Down) key to
move the cursor back and enter correct number
STATION SPEED DIAL
ALL SYSTEMS
in Part 1 for key descriptions.)
MMC 105 (Page 1 of 2)
MMC 606, Assign Speed
MMC 106)
DISPLAY
[201] SPEED DIAL
00 :
[205] SPEED DIAL
00 :
[205] SPEED DIAL
NO SPEED BLOCK
[205] SPEED DIAL
05: _
[205] SPEED DIAL
05 : 9-08104264100_
MMC PROGRAMS
FEBRUARY 2004
and #. If