Samsung DCS Programming Manual page 201

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 508
FOR:
Purpose: Sets the Call Cost attributes generated by the system during a call. This in-
formation can be displayed on the keyphone LCD during a call or as an SMDR record.
Attributes are as follows:
0 UNIT COST PER MP
When the system is configured to receive MP on a C.O. outgoing call, this is used for
generating total call cost by multiplying it by the number of pulses. Allows a maximum
value of 5000. The value is displayed as ECENT (Euro cents) or PENCE depending on
whether the 'USE EURO' option in
1 CALL COST RATE (%)
This generates additional call cost calculated by multiplying this rate by the original call
cost. Ranges from 100 to 250.
WARNING
•
Changing a value when there is a call in progress may result in an inaccurate call
cost.
•
This MPD facility requires the Meter Pulse Detection version of the trunk card. It is
not available on the standard product.
ACTION
1. Open programming and select 508
Display shows
2. Dial 0 or 1 (e.g. 1)
OR
Press VOLUME keys for selection and press
RIGHT soft key to move cursor
3. Enter new value (e.g. 110 for 110 percent)
System returns to step 2
4. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data:
Related Items:
ALL SYSTEMS
MMC 210
UNIT COST PER MP=0200 pence / Ecent
CALL COST RATE=100%
MMC 110 Station On/Off
MMC 210 Customer On/Off
MMC 414 MPD/PRS Signal
MMC 508 (Page 1 of 1)
CALL COST
is set on or off.
DISPLAY
UNIT COST PER MP
0200 PENCE→
CALL COST RATE
100% →_
CALL COST RATE
110% →
MMC PROGRAMS
FEBRUARY 2004