Configuring The Network Parameters Using The Mmc 830; Configuring The Installation Tool Parameters - Samsung OfficeServ 7030 Installation Manual

CHAPTER 6. Connecting extensions and devices
Below are the steps for connecting a PC for programming to the system.
1) Configure the network parameters using MMC 830.
2) Configure the Installation tool parameters.

6.2.5 Configuring the network parameters using the MMC 830

This step configures the network parameters of the OfficeServ 7030 system. Consult your
network administrator for the network parameter values. (See also section 2.4)
1) Set the IP addresses of the OfficeServ 7030 system. (Master and Slave)
2) Set the subnet mask of the OfficeServ 7030 system.
3) Set the gateway IP address of the OfficeServ 7030 system.
4) Reset the board.
Resetting the Board
You have to reset the board to apply the new settings. If the board is not reset
correctly, it may cause product malfunction.

6.2.6 Configuring the Installation Tool parameters

1) Run the Installation Tool.
2) On the main screen of the Installation Tool, select [System]
click the Port Basic icon.
6-10
Figure 6.11 Installation Tool
[Link Control] or
© SAMSUNG Electronics Co., Ltd.