Setting Network Parameters Through Mmc 830 - Samsung OfficeServ 7200-S Installation Manual

OfficeServ 7200-S
TECHNICAL MANUAL
MP20S
NOTE: Installation Tool must be version 1.43A or higher.
Detail procedures for each of the steps above are as follows:

SETTING NETWORK PARAMETERS THROUGH MMC 830

Set the network parameters of the system. Contact the network manager when setting values
for the network parameters.
1) Set the IP address of the system.
2) Set the subnet.
3) Set the gateway address.
4) Reset the MP20S.
MP20S Reset
New settings are applied only after the card is reset. The system may malfunction if
the card is not properly initialized.
Figure 7.27 OIT Connection to LAN Port
7.32
PART 7 MAY 2010
LAN
Home Page
INSTALLATION
Installation Tool