Samsung DCS Programming Manual page 302

SAMSUNG
COMBINED SYSTEMS PROGRAMMING MANUAL
MMC: 737
FOR: DCS CI CII
Purpose: Identifies your DECT system and the handsets you register with your system.
The DECT System Code for your system is made up of two fields: the System ID which
is three hexadecimal digits in the range 001 to 999; and the Auth Code (short for Authen-
tication Code) which is four hexadecimal digits in the range 0000 to 9999. The default
values are 000 and FFFF respectively.
You must use this MMC to change the default values for the values you have been
provided with by your supplier. If you do not change the defaults you will not be
able to register handsets.
Once you have entered your new System ID and Auth Code using this MMC you can
then begin registering your handsets with the Auth Code. The system checks the Auth
Code entered for each handset against the DECT Auth Code. If it is the same, the regis-
tration procedure continues; otherwise, the DCS rejects the registration procedure.
Caution: Only the system administrator and/or installer should be allowed access
to change the DECT System Code and register handsets.
ACTION
1. Open programming and select 737
Display shows
2. Press RIGHT soft key to move cursor and enter
AUTH CODE (e.g. 1234)
3. Press RIGHT soft key and press VOLUME keys to
select SYSTEM ID
4. Press RIGHT soft key to move cursor and enter
SYSTEM ID (e.g. 567)
5. Press Transfer/TRSF to store and exit
OR
Press SPEAKER to store and advance to next
MMC
Default Data:
Related Items:
iDCS100 iDCS500
Auth Code FFFF
System ID 000
(These values must be changed by the installer)
MMC 738 DECT Clear Registration
MMC 739 BSI Download
MMC 741 BSI Card Restart
MMC 742 BSI Status
MMC 743 DBS Status
MMC 744 DECT Registration On/Off
MMC 745 BSI Carrier
MMC 737 (Page 1 of 1)
DECT SYSTEM CODE
OS500
Important:
DISPLAY
DECT SYSTEM CODE
AUTH CODE : FFFF
DECT SYSTEM CODE
AUTH CODE : 1234
DECT SYSTEM CODE
SYSTEM ID : 000
DECT SYSTEM CODE
SYSTEM ID : 567
MMC PROGRAMS
FEBRUARY 2004