Yealink SIP-T2 SERIES Administrator's Manual page 91

Details of Configuration Parameters:
Parameters
network.internet_port.type
Description:
Configures the Internet (WAN) port type for IPv4.
0-DHCP
1-PPPoE (not applicable to SIP-T42G/T41P/CP860 IP phones)
2-Static IP Address
Note: It works only if the value of the parameter ―network.ip_address_mode‖ is set to
0 (IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the IP phone will reboot to
make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port->IPv4
To configure DHCP via web user interface:
1. Click on Network->Basic.
2. In the IPv4 Config block, mark the DHCP radio box.
3. Click Confirm to accept the change.
Phone User Interface
Permitted Values
http://<phoneIPAddress>/servlet
?m=mod_data&p=network&q=l
oad
Configure DHCP on the IP phone.
0, 1 or 2
Getting Started
Default
0
69