Yealink SIP-T2 SERIES Administrator's Manual page 843

Details of the Configuration Parameter:
Parameters
video.enable
Description:
Enables or disables the video call feature for the IP phone.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), video is not sent in outgoing calls and not received in
incoming calls. All calls are audio only.
If it is set to 1 (Enabled), video is sent in outgoing calls and received in incoming
calls.
Note: If you change this parameter, the IP phone will reboot to make the change take
effect. It is only applicable to SIP VP-T49G IP phones.
Web User Interface:
Settings->Video->Video Active
Phone User Interface:
Menu->Basic->Video Setting->Video Enable
video.auto_start_video.enable
Description:
Enables or disables the video transmission from the near site starts when a call
starts.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), video transmission from the near site does not start. It
means the IP phone will not transmit the video when a video call starts and the other
party cannot see you before you turn on the video.
Note: It is only applicable to SIP VP-T49G IP phones.
Web User Interface:
Settings->Video->Auto Start Video
Phone User Interface:
Phone User Interface
Configuring Video Features
?m=mod_data&p=settings-cam
era&q=load
Configure the video settings.
Permitted Values
0 or 1
0 or 1
Default
1
1
821