Yealink SIP-T2 SERIES Administrator's Manual page 326

Administrator's Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
To configure auto redial via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Auto Redial.
3. Enter the waiting time in the Auto Redial Interval (1~300s) field.
The default waiting time is 10s.
4. Enter the desired times in the Auto Redial Times (1~300) field.
The default value is 10.
5. Click Confirm to accept the change.
To configure auto redial via phone user interface:
1. Press Menu->Features->Auto Redial.
2. Press
Redial field.
3. Enter the waiting time (in seconds) in the Redial Interval field.
4. Enter the desired times in the Redial Times field.
5. Press the Save soft key to accept the change.
Auto answer allows IP phones to automatically answer an incoming call. IP phones will
not automatically answer the incoming call during a call even if auto answer is enabled.
Auto answer is configurable on a per-line basis. Auto-Answer delay defines a period of
delay time before the IP phone automatically answers incoming calls.
Auto Answer Tone
Auto answer tone allows the IP phone to play a tone when an incoming call is
automatically answered. You can customize the auto answer tone or select specialized
tone sets (vary from country to country) for your IP phone. For more information, refer to
Tones on page 778.
304
or , or the Switch soft key to select the desired value from the Auto