Yealink SIP-T2 SERIES Administrator's Manual page 57

You can connect an external monitor to the IP phone to have a clearer view with the far
site during a video call.
To connect an external monitor:
1) Remove one piece of the fastener's liner; take the gap of the camera as the
touchline and attach the fastener to the camera from the top; connect one end of
the USB3.0 cable to the camera.
2) Remove the other piece of the fastener's liner; attach the fastener to the external
monitor; attach the camera to the external monitor by pressing two sides of Dual
Lock together. You are advised to attach the camera to the external monitor whose
back is straight.
3) Connect the other end of the USB3.0 cable to the IP phone.
4) Connect one end of the HDMI cable to the HDMI port on the phone, and connect
the other end to the HDMI port on the external monitor.
Note
The Extended Display Accessories ED10 which is not included with your IP phone is
required for connecting the external monitor. Contact your reseller to purchase it
separately. For more information, refer to
Installation Guide for SIP VP-T49G
The following tips you need to know when mounting the camera to the external monitor:
a) Be aware of attaching the camera to the external monitor from the back of the
monitor and make sure the camera lens is on the same side with the monitor screen.
b) Confirm that the camera is vertical and not askew when using Dual Lock to attach
the camera to the external monitor otherwise the near-site video image will be
crooked.
c) Make sure that you firstly press the back of the camera when you rotate the camera.
It can reduce the risk of falling off.
d) Be aware that the stick area of two sides of Dual Lock (on the camera and external
Yealink Extended Display Accessories Quick
.
Getting Started
35