Yealink SIP-T2 SERIES Administrator's Manual page 708

Administrator's Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
Local
Details of Configuration Parameters:
Parameters
network.cdp.enable
Description:
Enables or disables the CDP (Cisco Discovery Protocol) feature on the IP phone.
0-Disabled
1-Enabled
Note: If it is set to 1, the IP phone will attempt to determine its VLAN ID through CDP .
If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->CDP->Active
Phone User Interface:
Menu->Settings->Advanced Settings (default password: admin)
->Network->CDP->CDP Status
network.cdp.packet_interval
Description:
Configures the interval (in seconds) for the IP phone to send the CDP (Cisco
686
Web User Interface
Phone User Interface
Permitted Values
0 or 1
Integer from 1 to 3600
Parameters:
network.cdp.enable
network.cdp.packet_interval
Configure CDP .
Navigate to:
For
SIP-T48G/T46G/T42G/T41P/T40P/T
29G/T27P/T23P/T23G/T21(P)
E2/T19(P) E2/CP860:
http://<phoneIPAddress>/servle
t?p=network-adv&q=load
For SIP VP-T49G:
http://<phoneIPAddress>/servle
t?m=mod_data&p=network-ad
v&q=load
Configure CDP feature.
Default
0
60