Digisol DG-GS4826S Management Manual page 1211

ip ospf
This command assigns a simple password to be used by neighboring
routers to verify the authenticity of routing protocol messages. Use the no
authentication-key
form to remove the password.
S
C
Interface Configuration (VLAN)
D
No password
C
u
u
u
E
This example sets a password for the specified interface.
R
ip ospf authentication (1209)
YNTAX
ip ospf [ip-address] authentication-key key
no ip ospf [ip-address] authentication-key
ip-address - This parameter can be used to indicate a specific IP
address connected to the current interface. If not specified, the
command applies to all networks connected to the current interface.
key - Sets a plain text password. (Range: 1-8 characters)
M
OMMAND ODE
S
EFAULT ETTING
U
OMMAND SAGE
Before specifying plain-text password authentication for an interface
with the ip ospf authentication
this command.
This command creates a password (key) that is inserted into the OSPF
header when routing protocol packets are originated by this device.
Assign a separate password to each network for different interfaces. All
neighboring routers on the same network with the same password will
exchange routing data.
A different password can be assigned to each network interface, but the
password must be used consistently on all neighboring routers
throughout a network (i.e., autonomous system).
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ip ospf authentication-key badboy
Console(config-if)#
C
ELATED OMMANDS
– 1211 –
C 48 | IP Routing Commands
HAPTER
Open Shortest Path First (OSPFv2)
command, configure a password with