Digisol DG-GS4826S Management Manual page 1233

Table 175: Open Shortest Path First Commands (Version 3) (Continued)
Command Function
ipv6 ospf retransmit- Specifies the time between resending a link-state
interval advertisement
ipv6 ospf transmit-delay Estimates time to send a link-state update packet over
an interface
passive-interface Suppresses OSPF routing traffic on the specified
interface
Display Information
show ipv6 ospf Displays general information about the routing
processes
show ipv6 ospf database Shows information about different LSAs in the
database
show ipv6 ospf interface Displays interface information
show ipv6 ospf neighbor Displays neighbor information
show ipv6 ospf route Displays the OSPF routing table
show ipv6 ospf virtual- Displays parameters and the adjacency state of virtual
links links
General Guidelines
Follow these basic steps to configure OSPFv3:
1.
Assign an IPv6 link-local address to each VLAN interface that will
participate in an OSPF routing process. You can automatically generate
a link-local address using the
an address to an interface using the
2. Use the router ipv6 ospf
process and enter router configuration mode.
3.
Use the router-id command to assign a unique identifier to the router.
Note that the default router ID of "0.0.0.0" cannot be used with the
current software version.
4. Use the ipv6 router ospf area
command to assign an area to each interface that will participate in the
specified OSPF process.
– 1233 –
C 48
HAPTER
Open Shortest Path First (OSPFv3)
ipv6 enable command, or manually assign
ipv6 address link-local
command to create a local OSPF router
command or the ipv6 router ospf tag area
| IP Routing Commands
Mode
IC
IC
RC
PE
PE
PE
PE
PE
PE
command.