Static Multicast Routing; Ip Igmp Snooping Vlan Mrouter; Table 139: Static Multicast Interface Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

| Multicast Filtering Commands
C 39
HAPTER

Static Multicast Routing

S M
TATIC ULTICAST
ip igmp snooping
vlan mrouter
Table 138: show ip igmp snooping statistics vlan query - display description
Field
General Query Received
General Query Sent
Specific Query Received
Specific Query Sent
Number of Reports Sent
Number of Leaves Sent
R
OUTING
This section describes commands used to configure static multicast routing on the
switch.

Table 139: Static Multicast Interface Commands

Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
This command statically configures a (Layer 2) multicast router port on the
specified VLAN. Use the no form to remove the configuration.
S
YNTAX
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
D S
EFAULT ETTING
No static multicast router ports are configured.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Depending on your network connections, IGMP snooping may not
◆
always be able to locate the IGMP querier. Therefore, if the IGMP
– 1028 –
Description
The number of general queries received on this interface.
The number of general queries sent from this interface.
The number of specific queries received on this interface.
The number of specific queries sent from this interface.
The number of reports sent from this interface.
The number of leaves sent from this interface.
Function
Adds a multicast router port
Shows multicast router ports
Mode
GC
PE