Settings - ABB REL650 series Technical Manual

1MRK 506 335-UUS A
6.3.5
Table 39: FMPSPDIS Group settings (basic)
Name Values (Range)
IMaxLoad 10 - 5000
RLd 1.00 - 3000.00
LdAngle 5 - 70
BlinderAng 5 - 90
Table 40: FMPSPDIS Group settings (advanced)
Name Values (Range)
DeltaIMinOp 5 - 100
DeltaVMinOp 5 - 100
V1Level 5 - 100
I1LowLevel 5 - 200
V1MinOp 5 - 100
V2MinOp 1 - 100
INRelPG 10 - 100
3I0BLK_PP 10 - 100
Table 41: FMPSPDIS Non group settings (basic)
Name Values (Range)
GlobalBaseSel 1 - 6
6.3.6
6.3.6.1
Technical manual

Settings

Unit Step
%IB 1
ohm/p 0.01
Deg 1
Deg 1
Unit Step
%IB 1
%VB 1
%VB 1
%IB 1
%VB 1
%VB 1
%IB 1
%IB 1
Unit Step
- 1
Operation principle
The phase selection function
Faulty phase identification with load encroachment for mho (FMPSPDIS, 21) function
can be decomposed into six different parts:
Default Description
200 Maximum load for identification of three phase
fault in % of IBase
80.00 Load resistive reach in ohm/phase
20 Load encroachment inclination of load angular
sector
80 Blinder angle
Default Description
10 Delta current level in % of IBase
20 Delta voltage level in % of Vbase
80 Positive sequence voltage limit for
identification of three phase fault
10 Positive sequence current level for
identification of three phase fault in % of IBase
20 Minimum operate positive sequence voltage
for phase selection
5 Minimum operate negative sequence voltage
for phase selection
20 3I0 limit for release Phase-Ground measuring
loops in % of maximum phase current
40 3I0 limit for blocking Phase-to-Phase
measuring loops in % of maximum phase
current
Default Description
1 Selection of one of the Global Base Value
groups
Section 6
Impedance protection
149