Reset-Set With Memory Function Block Rsmemory - ABB REL650 series Technical Manual

1MRK 506 335-UUS A
Table 397: SRMEMORY Group settings (basic)
Name Values (Range)
Memory Off
On
13.4.1.11
Technical manual
Signals
Table 395: SRMEMORY Input signals
Name Type
SET BOOLEAN
RESET BOOLEAN
Table 396: SRMEMORY Output signals
Name Type
OUT BOOLEAN
NOUT BOOLEAN
Settings
Unit Step
- -

Reset-set with memory function block RSMEMORY

Identification
Function description
Reset-set with memory function block
Functionality
The Reset-set with memory function block (RSMEMORY) is a flip-flop with memory
that can reset or set an output from two inputs respectively. Each RSMEMORY function
block has two outputs, where one is inverted. The memory setting controls if the flip-flop
after a power interruption will return the state it had before or if it will be reset. For a Reset-
Set flip-flop, RESET input has higher priority over SET input.
Default Description
0 Input signal to set
0 Input signal to reset
Description
Output signal
Inverted output signal
Default Description
On Operating mode of the memory function
IEC 61850 IEC 60617
identification identification
RSMEMORY
Section 13
Logic
ANSI/IEEE C37.2
device number
- -
553