ABB REL650 series Technical Manual page 803

1MRK 506 335-UUS A
18.3.3
Technical manual
Terminal Description
X331-12 Signal output 3
X331-13 Signal output 4, normally open
X331-14 Signal output 5, normally open
X331-15 Signal outputs 4 and 5, common
X331-16 Signal output 6, normally closed
X331-17 Signal output 6, normally open
X331-18 Signal output 6, common
Table 631: Output contacts X336, 3U full 19"
Terminal Description
X336-7 Signal output 1, normally open
X336-8 Signal output 1
X336-9 Signal output 2, normally open
X336-10 Signal output 2
X336-11 Signal output 3, normally open
X336-12 Signal output 3
X337-13 Signal output 4, normally open
X336-14 Signal output 5, normally open
X336-15 Signal outputs 4 and 5, common
X336-16 Signal output 6, normally closed
X336-17 Signal output 6, normally open
X336-18 Signal output 6, common
IRF
The IRF contact functions as a change-over output contact for the self-supervision system
of the IED. Under normal operating conditions, the IED is energized and one of the two
contacts is closed. When a fault is detected by the self-supervision system or the auxiliary
voltage is disconnected, the closed contact drops off and the other contact closes.
Each signal connector terminal is connected with one 14 or 16 Gauge wire.
Section 18
IED physical connections
PCM600 info
Hardware module Hardware channel
instance
BIO_5 BO7_SO
BIO_5 BO8_SO
BIO_5 BO9_SO
PCM600 info
Hardware module Hardware channel
instance
BIO_6 BO4_SO
BIO_6 BO5_SO
BIO_6 BO6_SO
BIO_6 BO7_SO
BIO_6 BO8_SO
BIO_6 BO9_SO
797