Siemens HiPath 5000 Service Manual page 1075

Table A-3 Expert Mode Codes
Code
20 6 1
20 6 2
20 7
20 8
20 8 1
20 8 2
20 8 3
20 8 4
21
21 1
21 2
21 3
21 4
21 5
21 6
21 7
21 8
22
22 11
22 12
22 13
22 13 1
22 13 2
22 13 2 1
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
System Programming Codes (Expert Mode Codes)
System number
Group number
Keypad dial: 0 = denied, 1 = allowed
System station number - outgoing
Port number
National number
International number
Suppress station number
Analog CO interface
Dialing method; select slot/trunk:
0 = Automatic,
1 = DTMF,
2 = Dial pulses
3 = MFC-R2,
4 = MFC-R2 with OAD
Delayed dialing; select trunk group:
0 = No pause, 1 = 1 s, 2 = 3 s, 3 = 6 s, 4 = 9 s
Trunk call pause; select trunk group: 1 = 6 s, 2 = 13 s
Line Length; select slot and trunk: 0 = Short 1 = Long
Charge data module, select slot/trunk: 0 = off, 1 = on
Silent reversal: 0 = no, 1 = yes
Port status: 0 = on, 1 = Off (SW), 2 = Off (HW), 3 = Off (HW, SW)
Allocated without extension
System settings
Music on Hold (MOH): 0= Off, 1 = No ring tone, 2 = Ring tone, 3 = An-
nouncement device 1
Internal Phonebook: 0 = No, 1 = Internal, 2 = LDAP, 3 = All
V.24 (RS-232) configuration
Select CB baud rate: 1 = 9600 baud, 2 = 2400 baud, 3 = 19200 baud
Port assignment
CSTA/CDRC (call detail recording central), output: 0 = none, 1 = V.24
port, 2 = UPN port, 3 = PC-VPL, 4 = LAN
Function
pcodes.fm
A-17